Pioneer KRP-500A Operating Instructions Manual page 18

05 Preparation
Attaching the ferrite core
(when a ferrite core is not attached)
To help prevent noise, attach the supplied ferrite core to the
connector end of the display and the Media Receiver's power cords
as shown. Use the supplied cable tie to prevent the ferrite core from
slipping on the cable.
1
Connecting the SYSTEM cable
Connecting the SYSTEM cable to the display
Display (rear)
Connecting the SYSTEM cable to the Media Receiver
Media Receiver (rear)
Caution
• Do not use the SYSTEM cable to connect other equipment to
the flat screen TV.
18
En
4
2
3
To power outlet
AC power cord
Note
• If it is already attached, do not remove the ferrite core from the
power cord. It should be permanently attached.
SYSTEM cable
Note
• The SYSTEM cable comes with the same terminals on both ends.
• Do not connect an HDMI cable to the SYSTEM CABLE terminal.
• When removing the SYSTEM cable, push and hold the latch on
the connector to release.
Ferrite core
Cable tie
To display and
Media Receiver
As close as possible