Changing Channels - Pioneer KRP-500A Operating Instructions Manual

06 Watching TV
Flat screen TV status indicators
The table below shows the operational status of the flat screen TV. You can check the current status of the system with the indicators on
the display and Media Receiver.
Display
Power ON STANDBY
For other than the above, see Troubleshooting on page 65.
Note
• You can select "Auto", "High", "Mid" or "Low" for the brightness
of the Power ON indicator. When "Auto" is selected, the
brightness of the indicator changes to "High", "Mid" or "Low"
to match the brightness level of the viewing area. For details,
see Blue LED Dimmer on page 43.

Changing channels

Use the remote control or the control panel of the Media Receiver
to change channels.
• Before operating with the remote control unit, make sure to
select the TV mode using its SELECT button. See Controlling
other equipment using the supplied remote control unit on
page 53.
Switching the TV input mode
• Press INPUT on the Media Receiver to select TV input mode.
Media Receiver (front)
ON STANDBY
STANDBY/ON
INPUT
INPUT
22
En
Indicator status
Media Receiver
Power ON STANDBY
SLEEP
VOLUME CHANNEL
CHANNEL+/–
The power cord of both the display and Media Receiver have been connected but the Power
On (a) button of the display is off.
Power to the system is on
The system is in standby mode
Using P+ / P– on the remote control unit
• Press P+ to increase the channel number.
• Press P– to decrease the channel number.
Note
• CHANNEL +/– on the Media Receiver operates the same as P+/
P–.
• Press CH RETURN to switch back to the previous channel.
Press CH RETURN again to return to the current channel.
• P+/P– cannot pick up channels that are set to skip. For Channel
Skip, see steps 13 and 14 under Setting up TV channels
manually on page 28.
System status
1 2 3
4 5 6
7 8 9
CH CH
0
RETURN ENTER
P
Channel display
8
AAA
STEREO
STANDARD
FULL