Service
manual
Replacing/adjusting
gas burner/gas valve/
ignition electrode/flame sensor
1. Disconnect power to the dryer.
2. Fig 1 Dismount the top back plate A.
3. Fig. 2 Remove the 6 screws B in order to
dismount the 2 gas burners with valves and
the control box.
4. Fig. 3 Replace/adjust electrode/flame
sensor/gas burner/gas valve.
5. Fig. 4 Check the distance between the
electrodes (see Gas error earlier in this
section).
7. Test for leaks.
8. Remount in the opposite order.
Test run
Note! To ensure the correct amount of air
to the combustion, plate A (fig. 1) must be
mounted before starting the dryer.
Heating - gas
1
A
2
B
3
4
3.5 mm ±0,5
5 mm
±0.5
69