Operation; Operating Controls - Kenwood TH-26A Instruction Manual

4. OPERATION
4-1, OPERATING CONTROLS
CDAntenna connector
Connect the antenna that is supplied to this connector.
Twist to lock.
(VVolume control
I
Power switch
The volume control and power switch are combined .
Rotating the control clockwise will turn ON the
transceiver. Advancing the control further clockwise
will increase the volume .
@SQL control
This control is used to select the desired Squelch
threshold level.
@MHzkey
This key is used to select the tuning rate of the Tuning
control. When the MHz indicator is lit, the Tuning
12
control will cause the transceiver to increase or decrease
in 1 MHz steps.
Press and hold the key for longer than 1 second to
initiate MHz scan. Pressing the key after scan has been
initiated will cause scan to stop.
Pressing the key within 10 seconds of pressing the F key
will allow you to change the frequency step.
Turn the power on while pressing this key to initiate the
Automatic Memory Initialization. Automatic storage
will then begin from the frequency that appeared in
the display before the power was turned off. See
section
4-4-8
for additional information on this
functi on.
@VFO key
This key is used to return to VFO operation after
operating in the memory channel or CALL channel
mode. The Tuning control will increase or decrease
frequency in accordance with the VFO indicator.
Press and hold the key for longer than 1 second -to
initiate VFO scan. Pressing the key after scan has been
initiated will cause scan to stop.
Pressing the key within 10 seconds of pressing the F key
will copy the memory channel or call channel data to
the VFO. This allows you to change parameters or that
channel without actually changing the data that has
been stored in memory.