Dtss (Dual Tone Squelch System) - Kenwood TH-26A Instruction Manual

Notes
1. While the stored DTMF code is recalled,
transmission continues until the whole code string
is recalled even if the PTI switch is released.
2. If you want to stop output of the stored DTMF code
midway, release the PTI switch once and then press
it again.
;::' : ::9 ;":: ':: ::,:" ',:"~
r
pe
- - _, '
I
seconds press the A, B, C or D _
key. The DTMF code stored in
the key will be output to the
FIJ -
:":1_
display.
C
The code is displayed from
right to left as illustrated.
To cancel the display halfway,
~
press any key.
~
[ Pc3~
I
4-12. DTSS (Dual Tone Squelch System)
FUNCTIDN [Requires optional DTU-1J
This function allows squelch to be turned on in receive
mode on reception of a three-digit code matching the
DTSS code selected in your radio.
Once squelch is turned on by reception of a matching
code, squelch operates normally from then on. If no
signal is received for longer than 2 seconds, squelch is
turned off until a matching code is received .
Note
This function is not available in some areas.
• Selecting and Storing the DTSS code
DTSS codes from 000 through 999 can be selected from
the VFO mode and stored in memory. Memory channels
1 through 3 can each store a separate DTSS code .
Memory channels 4 through 20 can store DTSS codes
with VFO .
OSelecting and Storing the DTSS code with VFO
1.
Press the F key for longer
than 1 second. Press the
SHIFT key while the F
indicator is flashing (for 10
seconds). This enters code
selection mode and the first
digit begins to flash.
SHIFT
For longer than 1 second
\
,
,
r
' n-nn
...
:~-uu
39