Siemens SINUMERIK 828D Function Manual page 642

Hide thumbs Also See for SINUMERIK 828D:
Table of Contents

Advertisement

K1: Mode group, channel, program operation, reset response
9.15 Replacing functions by subprograms
System variables
System variable
$C_M_PROG
$C_M
$C_AUX_VALUE[0]
$C_ME
$C_AUX_EXT[0]
$C_AUX_IS_QUICK[0]
$C_T_PROG
$C_T
$C_TE
$C_TS_PROG
$C_TS
$C_TCA
$C_DUPLO_PROG
$C_DUPLO
$C_THNO_PROG
$C_THNO
$C_D_PROG
$C_D
$C_DL_PROG
$C_DL
$P_SUB_STAT
642
Meaning
TRUE, if the M function has been programmed
For $C_M_PROG == TRUE, contains the value of address M
We must differentiate between two cases here:
$C_M supplies the value if, for the tool change with M
function, a subprogram is configured with parameter transfer:
MD10715 MN_M_NO_FCT_CYCLE
If only one subprogram is configured for the addresses T
and/or D/DL and if in the program the M function for the tool
change is programmed together with one of the addresses to
be replaced, then $C_M supplies the value: MD22560
$MC_TOOL_CHANGE_M_CODE
Value of the replaced M function
For $C_M_PROG == TRUE, contains the value of the address
extension of the M function
Address extension of the M function(identical to $C_ME)
TRUE, if the M function was programmed with quick output to the
PLC
TRUE, if the T function was programmed
For $C_T_PROG == TRUE, contains the value of the T function
Contains for:
$C_T_PROG == TRUE
$C_TS_PROG == TRUE
the value of the address extension of the T function
TRUE, if for the T or TCA replacement, a tool identifier has been
programmed.
For $C_TS_PROG == TRUE, contains the tool identifier
programmed for the T or TCA replacement
TRUE, if the TCA replacement is active
TRUE, if the duplo number of the TCA replacement has been
programmed
For $C_DUPLO_PROG == TRUE, contains the value of the
programmed duplo number
TRUE, if the toolholder/spindle number of the TCA replacement
has been programmed
For $C_THNO_PROG == TRUE, contains the value of the
programmed toolholder/spindle number
TRUE, if the D function has been programmed
For $C_D_PROG == TRUE, contains the value of the D function
TRUE, if the DL function was programmed
For $C_DL_PROG == TRUE, contains the value of the DL
function
Block-related time that the replacement subprogram is called
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Basic Functions

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinumerik 840d sl

Table of Contents

Save PDF