Tool holder-specific auxiliary functions, M6 auxiliary functions
System function
Tool change
Tool change
Tool change
(
The value can be changed.
)
1)
The value is depends on the machine data:
MD22560 $MC_TOOL_CHANGE_M_MODE (M function for tool change)
The value can be preset with a different value using the following machine data:
2)
MD20095 $MC_EXTERN_RIGID_TAPPING_M_NR (M function for switching over to the
controlled axis mode (ext. mode))
MD20094 $MC_SPIND_RIGID_TAPPING_M_NR (M function for switching over to
controlled axis mode)
Note
The value 70 is always output to the PLC.
The value is set using machine data:
3)
MD22254 $MC_AUXFU_ASSOC_M0_VALUE (additional M function for program stop)
The value is set using machine data:
4)
MD22256 $MC_AUXFU_ASSOC_M1_VALUE (additional M function for conditional
stop)
The value is set using machine data:
5)
MD10714 $MN_M_NO_FCT_EOP (M function for spindle active after reset)
6)
The value is set using machine data:
MD26008 $MC_NIBBLE_PUNCH_CODE (definition of M functions)
Basic Functions
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Index <n>
Type
298
M
299
M
300
M
H2: Auxiliary function outputs to PLC
8.2 Predefined auxiliary functions
Address
Value
extension
18
1)
6
19
1)
6
20
1)
6
Group
166
167
168
411