Connecting T1/E1 Cables
The figure below shows how the cable is connected between the 32 x T1/E1 interface module and the patch
panel.
Figure 49: Cable Installation between 32 x T1/E1 Interface and Patch Panel
1
T1/E1 Pinouts
For information about the pinout of the cable connecting the T1/E1 interface to the rear of the patch panel,
see the T1/E1 Port Pinout .
RJ45 Cable Pinouts
T1 lines from individual subscribers are attached to RJ45 connectors on the front of the 24-port patch panel.
Each RJ45 port accommodates an individual T1 subscriber line.
For the T1/E1 ports, see the T1/E1 Port Pinout .
RJ48 Cable Pinouts
T1 lines from individual subscribers are attached to RJ45 connectors on the front of the 24-port patch panel.
Each RJ45 port accommodates an individual T1 subscriber line.
For the T1/E1 ports, see the T1/E1 Port Pinouts (RJ-48) section.
Cisco ASR 907 Router Hardware Installation Guide
108
Installing the Cisco ASR 907 Router
Patch panel interfaces