Back Up - Hitachi PXR Service Manual

2.9 Back up

- Copy "Printing data", "User pattern" and "Unit-specific data" on a memory card.
- Backup data can be copied on an IJ printer.
- Backup on a memory card
Mode
User mode
Service personnel
maintenance mode
* Data of up to 100 IJ printer units can usually be stored on one memory card.
However, data exceeding the capacity of memory card cannot be stored.
* The capacity of the data when saving at a memory card is approx. 220 k bytes in
the state at the time of shipment. And the capacity of data to save increases about
8 k bytes per one message.
- At the Service personnel maintenance mode, the copy data type can be select.
Data type
User pattern
Print data
User data
Unit-specific data
- When "Maintenance" is protected, release the protection before "backup" and protect
again after "backup".
- Only the print data and the user patterns that are backed up by the model PX can be
copied to the model PXR.
- The data backed up by the model PXR can not be copied to the model PX.
Copy from a memory card onto an IJ printer
1 Turn on the power.
2 Put it into the Service personnel maintenance mode by using
Password protection.
3 Press the Copy data on the Auxiliary function menu screen.
The "Copy data" screen then opens.
Copy data
Copy direction
Printer
Copy data of backup
Print data, substitution rules, user patterns, alphanumeric
patterns, Unit-specific data
Print data, substitution rules, user patterns, alphanumeric
patterns, Unit-specific data
Log management, Viscometer information,
Internal communication error analysis data etc.
Copy data from memory card to IJP
User patterns, alphanumeric patterns
Print data, Substitution rules
Print data, Substitution rules, User patterns,
alphanumeric patterns
Unit-specific data
(Ink viscosity coefficient, APH gain, User environment
setup, etc)
2011.07.07 12:45 Status:XXXXXXXXX
Mem. card Mem. card
2-27
Copy data
Copy data
Printer
Cancel