Automatic Discovery Of Ur Devices; Connect To The C30; Connect To The C30 In Enervista - GE C30 Instruction Manual

CONNECT TO THE C30

3.7.3 Automatic discovery of UR devices

The EnerVista UR Setup software can automatically discover and communicate to all UR-series IEDs located on an
Ethernet network.
Using the Discover button in the Device Setup window, a single click of the mouse triggers the software to detect
automatically any UR-series relays located on the network. The EnerVista UR Setup software then proceeds to configure all
settings and order code options in the window. This feature allows the user to identify and interrogate all UR-series devices
at a location.
To discover UR devices:
1. In EnerVista, click the Device Setup button.
2. In the window that opens, click the Discover button. If the required device is not found, add it manually as outlined
earlier.
3
3.8 Connect to the C30
There are four ways to the connect to the device, as follows:
• RS232 port (outlined here)
• RS485 port
• Ethernet port (outlined here)
• LAN

3.8.1 Connect to the C30 in EnerVista

For information on using the EnerVista software, see the Interfaces chapter.
To access the relay in EnerVista:
1. Open the Settings > Product Setup > Display Properties window as shown. The window opens with a status
indicator on the lower left of the EnerVista UR Setup window.
3-46
Figure 3-53: Discover button to detect UR devices in network
CHAPTER 3: INSTALLATION
C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL