GE C30 Instruction Manual page 277

CHAPTER 5: SETTINGS
5.8.7.2 Teleprotection inputs
SETTINGS  INPUTS/OUTPUTS  TELEPROTECTION  TELEPROT INPUTS
 TELEPROT INPUTS

Setting the
TELEPROT INPUT ~~ DEFAULT
defaults the input to logic 0 when the channel fails.
The "Latest/On" and "Latest/Off" values freeze the input in case of lost communications. If the latest state is not known,
such as after relay power-up but before the first communication exchange, then the input defaults to logic 1 for "Latest/
On" and logic 0 for "Latest/Off."
5.8.7.3 Teleprotection outputs
SETTINGS  INPUTS/OUTPUTS  TELEPROTECTION  TELEPROT OUTPUTS
 TELEPROT OUTPUTS

As the following figure demonstrates, processing of the teleprotection inputs/outputs is dependent on the number of
communication channels and terminals. On two-terminal two-channel systems, they are processed continuously on each
channel and mapped separately per channel. Therefore, to achieve redundancy, the user must assign the same operand
on both channels (teleprotection outputs at the sending end or corresponding teleprotection inputs at the receiving end).
On three-terminal two-channel systems, redundancy is achieved by programming signal re-transmittal in the case of
channel failure between any pair of relays.
C30 CONTROLLER SYSTEM – INSTRUCTION MANUAL
TELEPROT INPUT 1-1

DEFAULT: Off

TELEPROT INPUT 1-16

DEFAULT: Off
TELEPROT INPUT 2-1

DEFAULT: Off

TELEPROT INPUT 2-16

DEFAULT: Off
setting to "On" defaults the input to logic 1 when the channel fails. A value of "Off"
TELEPROT OUTPUT 1-1:

Off

TELEPROT OUTPUT 1-16:

Off
TELEPROT OUTPUT 2-1:

Off

TELEPROT OUTPUT 2-16:

Off
Range: Off, On, Latest/Off, Latest/On
Range: Off, On, Latest/Off, Latest/On
Range: Off, On, Latest/Off, Latest/On
Range: Off, On, Latest/Off, Latest/On
Range: FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
Range: FlexLogic operand
INPUTS/OUTPUTS
5
5-159