Panasonic KX-NS1000 Installation Manual page 211

8.
In Easy Setup, select a value for Select the System Capacity Type under System Capacity Selection.
Note
The system component type selected in this step will be over-written with the following steps.
9. After Easy Setup is complete, click Utility ® File ® File Transfer PC to PBX.
10.
Select the local file that you saved in step 5, and then click Execute.
11. Click System Control ® System Reset.
12.
Click Skip.
13.
Click OK.
14.
Click OK.
Conditions
[Rules for data conversion]
The following table shows the rules for converting system data to a different type.
Condition
Components will increase
Components will decrease
Components are same
Parameters in components will increase
Parameters in components will decrease
Parameters in components are same
"Components" refers to the PBX's physical cards, virtual cards, etc. If the system component type is different
from before the conversion, the number of components will be increased, decreased or inherited.
The following table gives an example:
Maximum Cards in 1
Component
Type
1
V-SIPGW16 16
V-IPGW16 3
V-IPEXT32 8
V-SIPEXT32 20
V-UTEXT32 20
Copy information for inherited
components.
Set default value for added components.
Copy information for inherited
components.
Delete information for discarded
components.
Copy information for all the components.
Copy information for inherited parameters.
Set default value for added parameters.
Copy information for inherited parameters.
Delete information for discarded
parameters.
Copy information for all the parameters.
Unit
Type 1 ®
Type Type
Type 2
2 3
16 10 Same
3 6 Same
20 8 Increase
8 12 Decrease
8 12 Decrease
5.3 Starting Web Maintenance Console
Rule
Change in components after conversion
Type 2 ®
Type 3 Type 1
Decrease Same
Increase Same
Same Decrease
Decrease Increase
Decrease Increase
Type 3 ®
Type 3 Type 1
Decrease Increase
Increase Decrease
Decrease Same
Increase Increase
Increase Increase
Installation Manual
Type 2
Increase
Decrease
Increase
Decrease
Decrease
211