Operation
Power Switch
Connect the appliance to the power supply.
1.
Fill the tank with water to a level between the 'MIN' and 'MAX' marks on the inside of the tank.
2.
Note: BUFFALO recommend that fresh water be used each time the appliance is used.
Switch the power switch to the On position [I]. The red power indicator light will turn on.
3.
Turn the thermostat to the highest setting (90°C) to heat-up the appliance.
4.
Reduce the heat setting once the appliance has heated the water. An operating temperature of
5.
75°C - 80°C is sufficient.
Note: Do not allow the water to drop below the 'MIN' level during operation. Severe
damage to the heating element could result.
Maintaining Water Levels
It is important to regularly check the water level in the Bains Marie tank.
Always keep the water level above the 'MIN' mark on the inside of the tank during operation.
Damage to the heating element can occur if the tank boils dry and the element may have to be replaced.
This is not covered by the BUFFALO warranty.
Emptying the Appliance
Note: Always switch the appliance off allow the water to cool before emptying.
Use a suitable vessel to remove the water from the appliance.
L310/S047 Only - Turn on the tap to drain the water. Ensure a suitable container is used to collect the
water.
Cleaning, Care & Maintenance
Note: Always switch off and disconnect the appliance from the power supply before
cleaning.
Always allow the appliance to cool before emptying or cleaning.
•
Wipe down the exterior of the appliance with a damp cloth.
•
Some cleaning agents may cause damage when used for a prolonged period on stainless steel. Use a
suitable stainless steel cleaner such as Sanizap Stainless Steel Cleaner (Product code: U386).
•
Dry the exterior thoroughly.
•
Wash all removable parts in warm, soapy water.
Power Indicator Light
2
70
Thermostat Dial