Installation; Operation - Buffalo DC858 Instruction Manual

UK

Installation

To install the Pie Warmer:
1. Remove the Pie Warmer from the packaging. Make sure that all protective plastic film and coatings
are thoroughly removed from its surfaces.
2. Take the glass display panel and raise it at an angle into the upper track at the rear of the unit [Fig. 1].
3. Once at the top of the track, position the bottom of the glass above the lower track [Fig. 2].
4. Carefully lower the glass into the bottom track [Fig. 3].
5. Slide the wire racks into the bracket on the inner side of the Pie Warmer.
6. Insert the two sliding door panels in the same manner as the display panel. Ensure the handles are
located towards the outside edges of the appliance [Fig. 4].
7. Connect the plug to a suitable mains socket and turn on the power supply.

Operation

Note: This appliance is for maintaining temperature only. It is NOT suitable for
cooking products or heating products from cold.
1. Add water (0.5L) to the water reservoir
2. Set the thermostat to the desired temperature.
3. The unit will cycle on and off to maintain the set temperature.
The green indicator light and the interior lamp will turn on when the unit is switched on.
The green indicator light will turn off when the desired temperature has been reached.
Note: The appliance has a maximum temperature setting of 90°C.
4
DC858-DC859_ML_A5_v2 20200420.indb 4 2020/4/20 14:27