Hitachi Compute Blade 500 Series User Manual page 364

Entering the configuration utility in
this state results in drive
configuration changes.
Press Y to continue loading the
configuration utility or power off
your system and check your cables
to ensure that all the disks are
present, and then restart.
External Enclosure does not
support in controller's Direct
mapping mode. Contact your
system support.
System has halted due to
unsupported configuration.
Firmware did not find valid
NVDATA image.
Program valid NVDATA image and
restart your system.
Press any key to continue
Incompatible secondary iButton
present!
Please insert the correct iButton
and restart the system. Press any
key to continue but OEM-specific
features are not upgraded.
Invalid memory configuration
detected.
5-56
Message
SAS 3004 iMR ROMB Configuration Utility
Hitachi Compute Blade 500 Series EFI User's Guide
Description
Cause:
An inconsistency was found in the logical drive
configuration information.
Action 1:
a Press the Y key, and then press the Enter
.
key.
The following message appears: Critical
Message handling completed. Please exit.
b Press the ESC key.
.
The selection window appears.
c Press the Y key.
.
System startup continues.
Action 2:
If this message appeared, contact your reseller
or call maintenance personnel.
Cause:
The enclosure of the external disk array system
is incorrect.
Action:
If this message appeared, contact your reseller
or call maintenance personnel.
In addition, if this message appeared, the
system startup cannot continue.
Cause:
Valid firmware setting files were not found.
Action 1:
a Enter a character, and then press the Enter
.
key.
The following message appears: Critical
Message handling completed. Please exit.
b Press the ESC key.
.
The selection window appears.
c Press the Y key.
.
System startup continues.
Action 2:
If this message appeared, contact your reseller
or call maintenance personnel.
Cause:
The iButton is invalid.
Action:
If this message appeared, contact your reseller
or call maintenance personnel.
Cause:
Invalid memory information was detected.