Honeywell hus-nvr-1032-e User Manual page 70

System Operation and Configuration
64
Figure 5-71 System Management
You can upgrade firmware, restore to factory/default settings, export/import configuration file
and enable auto log off.
Upgrade Firmware Steps
1. Copy the upgrade file (".hdu" file) into a USB storage device and connect it to NVR.
Click Upgrade Firmware in the window above.
In the pop up window, select the upgrade file and click OK. It will display the version
2.
information of the current system and the upgrade file.
3. Click OK to start upgrade and wait until it shows that the upgrade is complete.
4. Click OK and a message pops up to ask for a system restart to apply the new
firmware version.
Export Configuration File
To export the configuration (except for the IP address setting) file to an external USB device,
click Export in the above window and the below window is displayed:
Figure 5-72 Export
Select the target USB device and file and then click OK to start exporting the configuration
file (Config_export.hdc) and wait until it shows that the exporting is complete.
Import Configuration File
To import a configuration file, copy the configuration file (".hdc" file) into a USB storage
device and connect it to the NVR. Click Import as shown in
window is displayed:
and the below
Figure 5-71