Honeywell hus-nvr-1032-e User Manual page 44

System Operation and Configuration
38
• It is recommended that to eject the disk by user interface
operation, otherwise, it will damage the disk or cause data loss.
• It is recommended that the ejection interval between two disks is
not less than 30 seconds.
Read/Write Type
To set a disk to READ-ONLY, right click the disk icon and select SetRead-Only.
•
• To set a disk to READ-WRITE, right click the disk icon and select SetRead-Write.
Ejecting Disk
To remove a disk from the NVR, right click the disk icon and select "Eject" in the pop-up
menu and the below window will be displayed:
Figure 5-19 Confirm Disk Ejection
Click OK to eject the disk. If it is the only available disk for recording then the below window
is displayed:
Figure 5-20 Eject
Click OK to stop recording and eject the disk.
• Do not directly pull out the disk during the ejection process.
• Do not remove the disk while it is still working to avoid losing data
and do not plug in the disk during system start up.