Honeywell hus-nvr-1032-e User Manual page 24

Basic Operations
18
Figure 4-5 Date & Time
3. Time zone, date and time can be set on the above tab. Click Next to go to the
"Network" tab as shown in the following figure:
Figure 4-6 Network Settings-1
4. You can set IP address for the NVR on this tab.
If select "Use the following IP address for LAN 1", you should manually set "IP Address",
"Subnet Mask" and "Gateway" respectively as shown in the following figure (the below
figure will change based on your DHCP settings):