Maintenance; Optional Accessories - Makita 3700B Instruction Manual

Remove the trimmer guide from the tool. Install the
trimmer shoe on the guide holder with the adjusting
screw and the clamp screw (B). Loosen the clamp
screw (B) and adjust the distance between the bit and
the trimmer shoe by turning the adjusting screw (1 mm
or per turn). At the desired distance, tighten the clamp
screw (B) to secure the trimmer shoe in place. When
cutting, feed the tool in the direction of the arrow on the
trimmer shoe.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
007116
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
1. Limit mark
1
1. Screwdriver
2. Brush holder
cap
1
2

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Router bits
Straight bit
005116
D
20 6
20E 1/4"
8 6
8E 1/4"
6 6
6E 1/4"
006485
"U"Grooving bit
005117
D
6 6
6E 1/4"
006486
8
or attachments
Only use accessory or
A L 1
20 50
8 50
6 50
R
A L 1 L 2
6 60 28
are
mm
L 2
15
18
18
mm
R
3