Cisco 2600 series Installation Manual page 16

Connecting the DC Power Supply
Before working on a chassis or working near power supplies, unplug the power cord on AC units;
Warning
disconnect the power at the circuit breaker on DC units. To see translations of the various
warnings that appear in this publication, refer to the Regulatory Compliance and Safety
Information document that accompanied this device.
Strip one end of the 6-AWG wire to expose approximately 0.75 in. (20 mm).
Step 2
Crimp the grounding lug around the wire. (See
Step 3
Figure 3-21 Crimping the Lug Around the Wire
Use the number 2 Phillips screwdriver to fasten the grounding lug to the chassis. (See
Step 4
Figure
Figure 3-22 Attaching the Grounding Lug on Cisco 261x, Cisco 262x, Cisco 26xxXM, and Cisco 265x
Grounding lug
Cisco 2600 Series Routers Hardware Installation Guide
3-16
3-23.)
Routers
Link
LED
CONN
SEE MANU AL BEFO RE INSTA LLATIO
LINK
ETH ERN ET 0/1
Grounding cable
Ethernet 0/1
10BASE-T
port (RJ-45)
Figure 3-21.)
Link
LED
ACT
ACT
LED
LED
SERIA L 1
SERIA L 0
WIC
CONN
2A/S
CONN
N
SEE MANU AL BEFO RE INSTA LLATIO
ACT
LINK
ETH ERN ET 0/0 ACT
CON SOL E
Ethernet 0/0
10BASE-T
port (RJ-45)
Console
port (RJ-45)
Chapter 3 Installing the Router
Figure 3-22
SERIA L 1 Cis co 261 1
SERIA L 0
WIC
CONN
2A/S
N
W0
AUX
Auxiliary
port (RJ-45)
or
OL-2171-02