Cisco 2600 series Installation Manual page 14

Connecting the DC Power Supply
Figure 3-19 DC-Input Power Supply Terminal Block
On/off
switch
Strip 3/16 in. of shielding from the free end of each power lead wire that is attached to the DC-input
Step 3
power supply.
Step 4 Insert the three power leads into the slotted wire receptacles on the terminal block. (See
The illustration shows the DC power supply terminal block. The proper wiring sequence is ground
Warning
to ground, positive to positive (line to L), and negative to negative (neutral to N). Note that the
ground wire should always be connected first and disconnected last. To see translations of the
warnings that appear in this publication, refer to the Regulatory Compliance and Safety
Information document that accompanied this device.
Cisco 2600 Series Routers Hardware Installation Guide
3-14
Positive
Ground
Negative
Chapter 3 Installing the Router
Figure 3-20.)
OL-2171-02