Table of Contents
Advertisement
Clock function
END
Press
again and again to switch
between the clock functions.
To confirm the settings of the clock
functions, press
seconds for an automatic
confirmation.
Setting the DURATION or END
1. Press
again and again until the display
shows
or
or
flashes in the display.
2. Press
or
to the set the values and
press
to confirm.
For Duration
first you set the minutes and
then the hours, for End
hours and then the minutes.
An acoustic signal sounds for 2 minutes after
the time ends.
or
setting flash in the display. The oven stops.
3. Turn the knob for the oven functions to the
off position.
4. Press any button or open the oven door to
stop the acoustic signal.
If you press
hours for DURATION
appliance goes to setting of the
END
function.
Setting the MINUTE MINDER
1. Press
again and again until
flash in the display.
Using the accessories
WARNING!
Refer to Safety chapters.
12
To set when the appliance must deactivate. Use only when an
oven function is set. You can use Duration and End at the
same time (time delay), if the appliance is to be activate and
deactivate automatically later.
or wait 5
.
first you set the
symbol and time
when you set the
, the
and "00"
Application
2. Press
or
to set the MINUTE
MINDER.
First you set the seconds, then the minutes
and then the hours.
At first, the time is calculated in minutes and
seconds. When the time you set is longer
than 60 minutes, the symbol
in the display.
The appliance now calculates the time in hours
and minutes.
3. The MINUTE MINDER starts automatically
after five seconds.
After 90% of the set time, an acoustic
signal sounds.
4. When the set time ends, an acoustic signal
sounds for two minutes. "00:00" and
flash in the display. Press any button or
open the oven door to stop the acoustic
signal.
If you set the MINUTE MINDER
when the DURATION or END
function operates, the symbol
comes on in the display.
Count Up Timer
Use the Count Up Timer to monitor how long
the oven operates. It is on immediately when the
oven starts to heat.
To reset the Count Up Timer, press and hold
and
. The timer starts to count up again.
The Count Up Timer cannot be used
with the functions: Duration
End
.
Inserting the accessories
Wire shelf:
comes on
,
www.zanussi.com
Advertisement
Table of Contents
