Installation; Technical Data - AEG 41102IU-MN User Manual

Problem
The oven does not heat up.
The lamp does not operate.
The display shows "12.00".
Steam and condensation
settle on the food and in the
cavity of the oven.
12.2 Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
We recommend that you write the data here:
Model (MOD.)
Product number (PNC)
Serial number (S.N.)

13. INSTALLATION

WARNING!
Refer to Safety chapters.

13.1 Technical data

Dimensions
Height
Width
Depth
13.2 Location of the appliance
You can install your freestanding
appliance with cabinets on one or two
sides and in the corner.
Possible cause
The necessary settings are
not set.
The lamp is defective.
There was a power cut.
You left the dish in the oven
for too long.
894 - 912 mm
599 mm
600 mm
Remedy
Make sure that the settings
are correct.
Replace the lamp.
Reset the clock.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
on the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.
.........................................
.........................................
.........................................
A
Minimum distances
Dimension
A
B
ENGLISH
B
A
mm
2
685
27