Install The Light; Attach The Emergency Release Rope And Handle - Craftsman 139.10158 Owner's Manual

INSTALLATION STEP 6

Install the Light

1. Press the release tabs on both sides of lens. Gently rotate lens
back and downward until the lens hinge is in the fully open
position. Do not remove the lens.
2. Insert an A19 incandescent (100 watt maximum) or compact
fluorescent (26W, 100W equivalent) light bulb into the light
socket. The lights will turn ON and remain lit for
approximately 4-1/2 minutes when power is connected. Then
the lights will turn OFF.
3. Reverse the procedure to close the lens.
4. If the bulb burns out prematurely due to vibration, replace
with a garage door opener bulb. Use A19, standard neck
garage door opener bulb for replacement.
NOTE: Do not use halogen, short neck, or specialty light bulbs as
these may overheat the end panel or light socket. Do not use LED
bulbs as they may reduce the range or performance of your
remote control(s).
INSTALLATION STEP 7

Attach the Emergency Release Rope and Handle

1. Insert one end of the emergency release rope through the
handle. Make sure that "NOTICE" is right side up. Tie a knot at
least 1" (2.5 cm) from the end of the emergency release rope.
2. Insert the other end of the emergency release rope through
the hole in the trolley release arm. Mount the emergency
release within reach, but at least 6 feet (1.8 m) above floor,
avoiding contact with vehicles to prevent accidental release
and secure with a knot.
NOTE: If it is necessary to cut the emergency release rope, seal
the cut end with a match or lighter to prevent unraveling. Ensure
the emergency release rope and handle are above the top of all
vehicles to avoid entanglement.
To prevent possible OVERHEATING of the end panel or light
socket:
Use ONLY A19 incandescent (100W maximum) or compact
l
fluorescent (26W maximum) light bulbs.
DO NOT use incandescent bulbs larger than 100W.
l
DO NOT use compact fluorescent light bulbs larger than
l
26W (100W) equivalent.
DO NOT use halogen bulbs.
l
DO NOT use short neck or specialty light bulbs.
l
100 Watt (Max)
Standard Light Bulb
Release Tab
To prevent possible SERIOUS INJURY or DEATH from a falling
garage door:
If possible, use emergency release handle to disengage
l
trolley ONLY when garage door is CLOSED. Weak or broken
springs or unbalanced door could result in an open door
falling rapidly and/or unexpectedly.
NEVER use emergency release handle unless garage doorway
l
is clear of persons and obstructions.
NEVER use handle to pull door open or closed. If rope knot
l
becomes untied, you could fall.
Trolley
Trolley
Release Arm
Emergency
Release Handle
17
Lens
Hinge
Overhand
Knot