Arlo Base Station Leds - NETGEAR Arlo Wire-Free User Manual

4. Press the On-Off button on the back of the base station.
The Power LED and Internet LED light green in about two minutes.
Your base station is set up.

Arlo Base Station LEDs

See the following image for explanations for green, amber, and blinking LEDs:
Set Up Your System
Power
Green
The base station
is powered on.
Blinking green
A firmware update
is in progress. DO
NOT TURN OFF THE
BASE STATION OR
CAMERAS.
Amber
The base station
is booting.
Off
The base station
is powered off.
7
Internet Camera
Green Green
The base station Cameras are
is connected to connected to the
the Internet. base station.
Blinking green Blinking green
The base station
The base station is
is attempting
sending data over
to sync with a
the Internet.
camera.
Amber Blinking amber
The base station is A camera is too
connected to the far from the base
router but did not station. Signal
get an Internet strength is weak.
connection.
Off Off
The base station is No cameras are
not connected to detected..
your router.