Arlo Camera Firmware Updates - NETGEAR Arlo Wire-Free User Manual

3. Wait for the Sync Status LED on the base station to light green.
4. Press and release the Sync button on top of the camera.
A blue LED on the camera blinks rapidly to confirm a successful sync.
After the camera syncs, the Power LED on the base station might start blinking.
This indicates that the camera's firmware is updating. For information about
firmware updates, see
5. Repeat for each camera.

Arlo Camera Firmware Updates

A firmware update might start after you sync a camera to the base station. If a
firmware update is in progress, the LED on the camera flashes alternating blue and
amber. After this, the LED is off for one to two minutes while the camera installs
the firmware. This update happens automatically.
Important: Do not open the battery door while an Arlo camera is updating and
installing firmware.
After the camera firmware update completes, the camera syncs to the base
station again and the LED flashes blue rapidly.
Set Up Your System
Arlo Camera Firmware Updates
11
on page 11.