Makita LS0814 Instruction Manual page 9

1
1. Sub fence
1
1. Sub fence
1
3
2
1. Turn base
2. Miter scale
3. Pointer
4. Grip
5. Lock lever
Guide fence has scale of every 10 mm increments. This acts as guide for cut-
006955
off piece.
Sub fence
007020
This tool is equipped with the sub fence which should ordinarily be positioned
as shown in the figure.
However, when performing left bevel cuts, set it to the left position as shown in
the figure.
007021
CAUTION:
• When performing left bevel cuts, flip the fence over to the left position as
shown in the figure. Otherwise, it will contact the blade or a part of the
tool, causing possible serious injury to the operator.
Adjusting the miter angle
006956
Loosen the grip by turning counterclockwise. Turn the turn base while pressing
5
down the lock lever. When you have moved the grip to the position where the
pointer points to the desired angle on the miter scale, securely tighten the grip
clockwise.
CAUTION:
• When turning the turn base, be sure to raise the handle fully.
4
• After changing the miter angle, always secure the turn base by tightening
the grip firmly.
9