Service Journal; Pre-Delivery Service; After The First 25 Hours - Husqvarna P 520D With cabin Operator's Manual

Pre-delivery service

1 Charge the battery for at least 4 hours at max. 5
amp.
2 Check coolant level and antifreeze.
3 Check and adjust tyre pressure (150 kPa, 1,5 bar,
21,8 PSI).
4 Make sure the correct amount of oil is in the
cutting unit's bevel gear.
5 Check that the right amount of oil is in the engine.
6 Check that there is oil in the transmission's oil
tank.
7 Fit cutting unit.
8 Adjust cutting unit:
Adjust cutting unit so that rear edge is about 6-9
mm higher than front edge.
Conduct a function test of the cutting deck height
adjustment. - Combi 132 X, Combi 155 X
9 Lubricate the universal drive shaft with grease.
10 Connect battery.
11 Fill with fuel and start engine.
12 Check that machine does not move in neutral.
13 Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Safety switch for parking brake.
6 –
English

Service journal

14 Tell customer about:
The requirement and advantages of servicing the
machine according to the service plan
Servicing and the influence of this journal on the
second-hand value of the machine.
The transmission warranty is only valid if front
and rear wheel rotation speed has be checked in
accordance with the service schedule. Adjust if
necessary according to the table values specified in the
workshop manual. Performed by authorized servicing
dealer. The system will be damaged if this adjustment is
not carried out.
At temperatures below 0 ° C, the machine must
be warmed up for at least 10 minutes for the
hydraulic oil and transmission to get hot.
Otherwise there is a risk of the transmission breaking
down thereby reducing the service life of the transmission.
Range of applications for BioClip function.
Complete proof of sale etc.
Pre-delivery service carried out. No outstanding
problems. Certified:
Date:
Mileage:
Signature:
Label:
After the first 25 hours
1 Change the engine oil and oil filter
2 Changing oil in transmission gearboxes (front and
rear).
3 Replace the engine's hydraulic oil filter
4 Check front and rear wheel rotation speed
according to the service schedule.