Assembling The Rops (Roll Over Protective Structure); Lowering The Rops (Roll Over Protective Structure) - Husqvarna P 520D With cabin Operator's Manual

ASSEMBLING AND ADJUSTMENTS
15 Fasten the lifting straps to the lifting points.
16 Attach another lifting strap through the rear part of the
cab.
17 Use the lifting straps to carefully lift the cab a few
centimeters. The cab should now be hanging freely a few
centimeters above the machine.
CAUTION! Make sure the studs are not damaged.
18 Slide the cab forwards in the machine's direction of travel
to release it from the machine.
19 Lift of the cab.
20 Place the cab as instructed in "Transport and storage".
21 Assemble the ROPS (Roll Over Protective Structure) See

"Assembling the ROPS (Roll Over Protective Structure)"

for more information.
Assemble the parts in the reverse order.
CAUTION! Take great care not to pinch the cables when
assembling the cab.
Assembling the ROPS (Roll Over
Protective Structure) - Accessories
1 Lift up the bar and place it over the steel attachments
behind the seat.
2 Fasten the bolts in the top hole.
3 Tighten the bolt correctly. The bolt should be tightened
with a torque of 47 Nm.
4 Fit the pin into the bottom hole.
18 –
English
Lowering the ROPS (Roll Over
Protective Structure) - Accessories
1 Remove the pin.
2 Lower the bar over the engine cover.
3 Fasten the pin in the middle hole.