Service Position For The Cutting Unit - Husqvarna P 520D With cabin Operator's Manual

The traffic kit fuses are located under the cover for the servo
housing.
1
2
1 Horn - 5 amp.
2 Parking lights - 5 amp.
• The air distributor must be unscrewed in order to obtain
better access to the servo housing. The air distributor is at
the bottom of the window inside the cab. Dismantle by
loosening the 4 screws and lifting off the air distributor.
• Unscrew the two screws holding the cover on the power
servo housing.
• A blown fuse is indicated by a burnt connector. Pull the
fuse from the holder when replacing. Do not use any other
type of fuse when replacing.
Fuses in cab roof.
1 2 3 4
1 Window wiper - 10 Amp.
2 Fan - 10 Amp.
3 Work light - rear - 10 Amp.
4 Low beam - 10 Amp.
5 Work light - front - 10 Amp.
34 –
English
MAINTENANCE AND SERVICE
5

Service position for the cutting unit

The cutting head can be placed in the service position to
provide easy access for cleaning, repairs and servicing. In the
service position the cutting unit is raised and locked in the
vertical position.
Placing in the service position
1 Position the machine on flat ground. Apply the parking
brake.
2 Raise the cutting unit halfway.
3 Turn off the motor.
WARNING! Never leave the universal drive
!
shaft of the machine with one end loose. If
the engine is started, damage can occur.
4 Remove the lifting eyes from the cutting unit.
5 Lower the cutting unit to the lowest position. The cutting
unit now hangs free at the back.
6 Remove the universal drive shaft completely. Lift off the
lock chains.
7 Disconnect the hydraulic hoses from the quick
connections on the machine. (Combi 132 X, Combi 155
X)
8 Remove the service strut from the cutting unit.
If it is the first time the service strut is removed, remove
the safety strap from the strut and place it in the storage
compartment under the seat.