Makita G SERIES Instructions For Use Manual page 26

To determine the total wattage required to run a particular electrical appliance or
tool, multiply the voltage figure of the appliance/tool by the amperage (amps)
figure of same. The voltage and amperage (amps) information can be found on a
name plate which is normally attached to electrical appliances and tools.
Applications
Incandescent lamp, Heater
Fluorescent lamp, Electric tool
Pump, Compressor
NOTE :
The above wattage chart is general guide only. Refer to your specific
■
appliance for correct wattage.
When you use two or more alternating current outlets at a time, be careful that
■
the sum of the appliances' power consumption does not exceed the value
specified in the above chart.
VOLTAGE DROP IN ELECTRIC EXTENSION CORDS
When a long electric extension cord is used to connect an appliance or tool with
the generator, a certain amount of voltage drop occurs in the extension cord which
lessens the effective voltage available to the appliance or tool.
The chart below has been prepared to illustrate the approximate voltage loss when
an extension cord of 100 meters is used to connect an appliance or tool to the
generator.
Nominal
cross A.W.G.
section
mm No.
2
0.75 18
1.27 16
2.0 14
3.5 12 to 10
5.5 10 to 8
Allowable No.of strands
current / strands dia.
A No./mm
7 30/0.18
12 50/0.16
17 37/0.26
23 45/0.32
35 70/0.32
Applicable Wattage (W)
G12000R
Resistance
1A 3A
Ω/100m
2.477 2.5V 8V 12.5V
1.486 1.5V 5V 7.5V 12V 15V 18V
0.952 1V 3V
0.517 ─ 1.5V
0.332 1V
─
− 20−
60 Hz
9,500
4,700
2,400
Current Amp.
5A 8A 10A 12A 15A
─ ─ ─
5V 8V 10V 12V 15V
2.5V 4V 5V 6.5V 7.5V
2V 2.5V 3.5V 4V
─
─
5V