Pre-Operation Checks ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・ ・6 - Makita G SERIES Instructions For Use Manual

4. PRE-OPERATION CHECK
CHECK ENGINE OIL
Before checking or refilling oil, be sure
generator is located on stable and level
surface with engine stopped.
1) Remove oil level gauge and check the
engine oil level.
2) If oil level is below the lower level "L"
refill with suitable oil (see table) to upper
level "F" after removing the engine oil
filler cap.
3) Change oil if contaminated.
(See "How-To" Maintenance.)
Oil capacity :
1.55 liters (Upper level)
NOTE :
The engine is equipped with an oil sensor
■
unit (hydraulic pressure detection type)
that will automatically stop the engine if
oil in the crank case is reduced below the
specified level. Should the engine be
automatically stopped, be sure to check
the amounts of fuel and oil.
When the oil is reduced below the
■
specified level, add new oil to the upper
limit. Since the oil sensor will not detect
the deterioration of oil, visually check the
quality or determine it by the specified
time and then change the oil if necessary.
(Refer to page 24.)
Recommended engine oil :
Use 4-stroke automotive detergent oil
of API service class SE or higher
grade (SG, SH or SJ is recommended).
SAE 10W-30 or 10W-40 is
recommended for general, all-
temperature use. If single viscosity oil
is used, select the appropriate
viscosity for the average temperature
in your area.
OIL GAUGE
UPPER
LEVEL
LOWER
Oil gauge
Upper level
Lower level
5W
Single grade
Multigrade
Ambient
temperature
− 6−
LEVEL
OIL FILLER CAP
10W
20W
#20
#30
10W-30
10W-40
#40