Operation; Maintenance - Makita PC5000C Instruction Manual

013145
And then insert the brush all the way into the groove of
the dust cover by using slotted driver or other
appropriate tool.
Dust bag
1
009846
To install dust bag, slip onto dust port. Always make
sure to slip onto dust port all the way until it stops so
that it does not come off during operation.
Remove dust bag when it begins to touch cutting
surface. This is a sign that it is full. Failure to empty bag
will lead to poor suction/pickup.
Connecting a vacuum cleaner
009845
When you wish to perform clean planing operation,
connect a Makita vacuum cleaner to your tool as shown
in the figure.
1. Dust bag
9

OPERATION

010273
Always use the top grip (auxiliary handle) and firmly hold
the tool by top grip and switch handle during operations.
Planing in corners
For PC5000C
Flush planing of corners is possible after first removing
the dust cover cap.
For PC5001C only
4
009883
Before performing the flush planing of corners, remove
the hex bolt which secures roller holder and base holder
and then take away the whole roller holder.
Next, loosen the hex socket head bolt and take away
the dust cover cap and then adjust the dust cover in a
proper position according to your work.
009884

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or
•
the like. Discoloration, deformation or cracks may
result.
1. Dust cover cap
2. The whole roller
1
holder
3. Hex socket head
bolt
4. Hex bolt
2
3