Premaintenance Procedures; Lubrication; Greasing The Bearings And Bushings - Toro 30381N Operator's Manual

Premaintenance
Procedures
Important: The fasteners on the covers of this machine
are designed to remain on the cover after removal.
Loosen all of the fasteners on each cover a few turns so
that the cover is loose but still attached, then go back
and loosen them until the cover comes free. This will
prevent you from accidentally stripping the bolts free
of the retainers.

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours (Grease more frequently
when operating conditions are extremely
dusty or sandy.)
Grease Type: No. 2 General Purpose Lithium Base Grease.
Important: Lubricate the grease fittings immediately
after every washing, regardless of interval specified.
Bearing life can be negatively affected by improper wash
down procedures. Do not wash down the unit when it
is still hot and avoid directing high-pressure or high
volume spray at the bearings or seals.
1. Wipe the grease fittings clean so foreign matter cannot
be forced into the bearing or bushing.
2. Pump grease into the fittings.
3. Wipe off excess grease.
32