Toro 30381N Operator's Manual page 16

Figure 23
1. Cab mount
10. Lower the cab into position by slowly and evenly
loosening the jacking bolts on each end of the jacking
tube (Figure 24).
Figure 24
1. Jacking bolts
11. At the rear mounting points, secure the cab to the
machine with a bolt (1/2 x 3 inches), steel washer (1/2
x 2–1/2 inches), rubber washer (1/2 x 2–1/2 inches)
and nut (1/2 inch) (Figure 25). Tighten all four cab
mount bolts until the rubber mounts are compressed
to a thickness of 2.2 cm (7/8 inch).
2. Rubber mount
2. Cab jack tube
1. Rubber mount
12. Tighten the bolts and nuts securing the rear cab mounts
to the ROPS posts (Figure 26 ). Adjust the floor jack if
the bolts are binding and difficult to remove.
1. Cab mount
2. ROPS post
13. Loosen the jacking bolts and remove the cab jack tube
from the cutouts in the cab floor (Figure 27).
16
Figure 25
2. 2.2 cm (0.875 inch)
Figure 26
3. Bolts & nuts
4. ROPS post