Toro 30381N Operator's Manual page 14

Figure 15
1. Rear bumper
3. Remove the two screws securing the winter frame floor
plate cover to the floor and remove the plate (Figure
16).
Figure 16
1. Floor plate cover
4. Carefully roll the winter frame assembly into position
while routing the drive shaft through the frame tube
(Figure 17).
2. Floor jack
2. Mounting screws
1. Drive shaft
Note: If the rear of the cab is not high enough to clear
the control handles, evenly tighten the jacking bolts
on each side of the cab jack tube to raise the rear of
the cab (Figure 18).
1. Jacking bolts
5. Route the hoses as follows:
•
Route the tank hose under the lift cylinder and
between the cylinder mounting brackets to the
valve (Figure 19).
•
Route the pressure hose along side the PTO shaft
to the valve (Figure 19).
Note: To emphasis the hose routing, the hoses are
shown without the hose covers installed.
14
Figure 17
2. Frame tube
Figure 18