Care And Maintenance; Service Information; Specifications - Black & Decker JU300CB Instruction Manual

Jump starter/inflator
Hide thumbs Also See for JU300CB:
Table of Contents

Advertisement

Available languages

Available languages

Inflating Other Inflatables Without Valve Stems
Inflation of other items requires use of one of the adapters (nozzles).
1. Select the appropriate nozzle, located on the inside back cover.
2. Insert appropriate adapter (i.e. needle) into connector (chuck) and close thumb latch.
3. Small items such as volleyballs, footballs, etc. inflate very rapidly.
4. Insert adapter (i.e., needle) into item to inflate to appropriate pressure.
5. Turn ON the Inflator Power Switch — inflate to desired pressure or fullness.
6. Remove adapter.
7. Switch the Inflator Power Switch OFF.
8. Recharge the unit before storing away.

CARE AND MAINTENANCE

Charging/Recharging
This product has a sealed lead acid battery that should be kept fully charged. Recharge before first use, immediately
after each use, and every 60 days if not used. Failure to do this may reduce the battery life dramatically. Refer to the
"Charging/Recharging" section of this Instruction Manual.
WARNING: The use of any accessory not recommended for use with this tool could be hazardous.

Service Information

Black & Decker offers a full network of company-owned and authorized service locations. All Black & Decker
Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool
service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black &
Decker location nearest you.
Battery Disposal
Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be disposed of properly.
Recycling is required — contact your local authority for information. Failure to comply with local, state and
federal regulations can result in fines or imprisonment.
WARNINGS
Do not dispose of the battery in fire, as this may result in an explosion.
Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to prevent shorting
(shorting can result in injury or fire).
Do not expose battery to fire or intense heat, as it may explode.

SPECIFICATIONS

Boost Ampere:
Battery Type:
Area Light:
Booster Cables:
Accessory Outlet:
300 instantaneous cranking amps
Sealed, high energy density, AGM, lead-acid, rechargeable, maintenance-free,
12 volt DC
Light Emitting Diode (LED)
6 AWG cables with 300 Amp heavy duty clamps
Self-resetting breaker 5 amps
30

Advertisement

Table of Contents
loading

Table of Contents