Omega Engineering 100/200 Series User Manual page 42

DBK32A
The DBK32A and DBK33 power cards attach directly to the P1 analog expansion bus where they supply
power to DBK analog expansion cards. The DBK32A and the DBK33 can be powered from an included AC
adapter, an optional DBK30A battery module, or from a +10 to +20 VDC source such as a car battery.
When installed in a DBK10 three-slot expansion chassis, the DBK32A or DBK33 supplies power
to the analog DBK [that is to receive power] via a CA-37-x cable.
If used with the DBK41 ten-slot expansion enclosure, the DBK32A or DBK33 installs into one of the analog
expansion slots on the DBK41's backplane. A power card in any DBK41slot (other than the leftmost, when
viewed from the rear) will power the other cards that are connected to the DBK41's backplane.
DBK34
module – provides 12 or 24 VDC with a 5.0 or 2.5 A-hr capacity (respectively). This module is an
Uninterruptable Power Supply (UPS) that can be used for in-vehicle testing where the vehicle's electrical
system will not affect acquisition device power during starter-current surge, or power-off.
DBK34A
classified as a UPS / Battery module. It is an improved version of the earlier DBK34. Like the DBK34, the
DBK34A can be used for in-vehicle testing where the vehicle's electrical system will not affect acquisition
device power during power during starter-current surge, or power-off.
pg. 8, OMB-DBK Basics
- provides ±15 VDC @ 500 mA.
If using a DBK32A or a DBK33 with a DaqBook or DaqBoard [ISA type], you must
entirely remove the shunt jumpers from JP1. Failure to do so will result in damage to the
8254 timer chip. Refer to the power card document modules and to the Daq device
Hardware sections of the DaqBook and DaqBoard [ISA] user's manuals for JP1 location
and configuration.
module – provides 12 or 24 VDC with a 5.0 or 2.5 A-hr capacity (respectively). This device is
DBK33
- provides ±15 VDC @ 250 mA and +5 VDC @ 1000 mA.
CAUTION
02-19-02
Daq Systems