General Power Tool Safety Warnings; Save All Warnings And Instructions For Future Reference; Additional Safety Rules For Tool - Makita MLT100 Instruction Manual

Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Wear safety glasses.
･
Do not place hand or fingers close to
the blade.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance
Directive,
Electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for cutting in wood.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN61029:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
For European countries only
EC Declaration of Conformity
We Makita Corporation
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Table Saw
Model No./ Type: MLT100
are of series production and
Conforms to the following European Directives:
2006/42/EC
of the European
on Waste Electric
Equipment and
environmentally compatible
) : 92 dB (A)
pA
) : 105 dB (A)
WA
as the responsible
END215-6
And are manufactured in accordance with the following
standards or standardised documents:
EN61029
The EC
502510830001, BM 502510830002
The EC Type-Examination per 2006/42/EC was
performed by:
TÜV Rheinland LGA Products GmbH
Tillystraße 2
D-90431 Nürnberg
Identification number 0197
The technical documentation is kept by:
Makita International Europe Ltd.
Technical Department,
Michigan Drive, Tongwell,
Milton Keynes, Bucks MK15 8JD, England
and
its
000230
ENE003-1
ENF002-2
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
ENG905-1
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for
future reference.
ADDITIONAL SAFETY RULES
FOR TOOL
SAVE THESE INSTRUCTIONS.
ENH022-5
1. Wear eye protection.
2. Do not use the tool in presence of flammable
liquids or gases.
3. NEVER use the tool with an abrasive cut-off
wheel installed.
4. Check the blade carefully for cracks or
damage before operation. Replace cracked or
damaged blade immediately.
5. Use only saw blades recommended by the
manufacturer and which conform to EN847-1,
and observe that the riving knife must not be
thicker than the width of the cut by the saw blade
and not thinner than the body of the blade.
7
Type-Examination Certificate
7.5.2013
Tomoyasu Kato
Director
Makita Corporation
3-11-8, Sumiyoshi-cho,
Anjo, Aichi, 446-8502, JAPAN
No.BM
GEA010-1
ENB095-1