Grip; Speed Indicator; Reverse Button; Main Power Button - Makita DUR365U Instruction Manual

NOTE:
The tool is automatically turned off after the tool is
•
left one minute without any operations.
Speed adjusting
2
1
015589
You can adjust the tool speed by tapping the main
power button.
Each time you tap the main power button, one of the speed
indicator lights up in order of Turtle(
is for low speed and
middle indicator for middle speed.
Reverse button for debris removal
WARNING:
Switch off the tool and remove the battery
•
cartridge before you remove entangled weeds
or debris which the reverse rotation function
can not remove. Failure to switch off and remove
the battery cartridge may result in serious personal
injury from accidental start-up.
015588
This tool has a reverse button to change the direction of
rotation. It is only for removing weeds and debris
entangled in the tool.
To reverse the rotation, tap the reverse button and pull
the trigger when the tool's head is stopped. The power
lamp starts blinking, and the tool's head rotates in
reverse direction when you pull the switch trigger.
To return to regular rotation, release the trigger and wait
until the tool's head stops.
NOTE:
During the reverse rotation, the tool operates only for a
•
short period of time and then automatically stops.
Once the tool is stopped, the rotation returns to
•
regular direction when you start the tool again.
1. Main power
button

2. Speed indicator

), middle, Rabbit(
for high speed , and the

1. Reverse button

1
If you tap the reverse button while the tool's head
•
is still rotating, the tool comes to stop and to be
ready for reverse rotation.
Nylon cutting head (optional accessory)
NOTICE:
The bump feed will not operate properly if the
•
head is not rotating.
015602
The nylon cutting head is a dual string trimmer head
).
provided with a bump & feed mechanism.
To cause the nylon cord to feed out, the cutting head
should be bumped against the ground while rotating.
NOTE:
If the nylon cord does not feed out while bumping the
head, rewind/replace the nylon cord by following the
procedures described under "Maintenance" .
ASSEMBLY
WARNING:
Always be sure that the tool is switched off and
•
battery cartridge is removed before carrying out any
work on the tool. Failure to switch off and remove the
battery cartridge may result in serious personal injury
from accidental start-up.
Never start the tool unless it is completely
•
assembled. Operation of the tool in a partially
assembled state may result in serious personal
injury from accidental start-up.
Installing the handle
3
015574
Insert the shaft of the handle into the grip. Align the screw hole
in the grip with the one in the shaft. Tighten the screw securely.
10
1. Most effective
cutting area
1

1. Grip

2. Handle
1
3. Screw
2