Connecting With Other Device - Samsung SNV-L6013R User Manual

installation & connection

ConneCTinG wiTH oTHer DeviCe

PoE Device
<SNV-L6013R>
Connecting a connector cable (Snv-L6014rm)
Connect the M12 male connector into the hole of the M12 Female connector of the camera.
This camera uses Female, D-coded types.
`
M
PoE (Power over Ethernet) is supported.
`
You are recommended to use a shielded network connector.
`
Connect this camera to a shielded network cable (STP).
`
J
Please, use 4 poles, Male, D-coded type external cables that meet the M12 specification.
`
Check whether the PoE device is properly connected to the ground.
`
12_ installation & connection
PoE Device
<SNV-L6014RM>
RX- TX+
TX- RX+
making a connection using the m12-rJ45 conversion cable (Snv-L6014rm)
Connect the M12 male connector for the conversion cable to the groove of the M12 Female connector for
your camera.
M12-RJ45 cable is sold separately.
`
M
powering and networking (Snv-L6013r)
Connect a camera to a PoE equipment.
Connect to a PoE (Power over Ethernet) enabled router's PoE connector.
`
J
Use PoE (Power over Ethernet) that is compliant with the IEEE802.3af protocols.
`
powering and networking (Snv-L6014rm)
Connect a camera to a PoE equipment or connect the M12-RJ45 connector for the conversion cable of your
camera to a PoE equipment.
A connection method may vary depending on the installation environment of a user.
`
J
Connect to a PoE (Power over Ethernet) enabled router's PoE connector.
`
Use PoE (Power over Ethernet) that is compliant with the IEEE802.3af protocols.
`
You can only use a Mode A PoE device that supplies power through data pin pair 1, 2, 3, 6.
Even if you use the M12-RJ45 conversion cable, you can only use a mode A type PoE equipment that supplies power to data
`
pair pins 1, 2, 3, 6.