Makita BUK360 Instruction Manual page 7

When only the lowermost indicator lamp (next to the
•
"E") blinks, or when none of the indicator lamps light,
the battery capacity has run out, so the tool does not
operate. In these cases, charge the battery or
replace the empty battery with a fully charged one.
When two or more indicator lamps do not light even
•
after charging is complete, the battery has reached
the end of its service life.
When the upper two and lower two indicator lamps
•
light alternately, the battery may have malfunctioned.
Contact your local Makita authorized service center.
NOTE:
The indicated capacity may be lower than the actual
•
level during use or immediately after using the tool.
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.
Battery converters (optional accessory)
WARNING:
Before installing or removing the battery converters
•
BCV01/BCV02, remove the lock key.
BCV01 (optional accessory)
WARNING:
When using the BCV01, be sure to use the holder
•
(optional accessory) to retain its cord. Failure to use
the holder leaves the cord loose. This may cause the
cord to be entangled by the blade, resulting in
damage to the tool and a personal serious injury.
When using the BCV01, never attach it to any part
•
of your body. Attaching the BCV01 to any part of
your body may cause a serious injury.
2
1. Battery converter (BCV01)
2. Installation hole
012932
Hook the battery converter BCV01 onto installation
section of the handle.
Holder (optional accessory)
When using the BCV01, be sure to use the holder
(optional accessory) to retain its cord.
012933
Fit the holder (optional accessory) in the hole on the left
side of the handle from the operator's view. And then
push the cord into the holder so that the cord tension is
not too loose. Make sure the cord is secured with the
cord holder.
1
012936
Open out the battery hood and then slide all the way and
click the product mounting adapter of the BCV01 into the
battery port 1.
1
012935
Pull up lightly and remove the rubber cap from the slit in
the lower housing as shown in the figure.
NOTE:
Do not pull up the rubber cap forcibly because
•
forcing it may damage its retaining section.
7
1. Holder
1
1. Battery port 1
2. Battery port 2
2
3. Rubber cap
2
1
3
1. Rubber cap
1