Functional Description - Makita 4076D Instruction Manual

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off before
•
adjusting or checking function on the tool.
Charging the built-in battery
Fig.1
Fig.2
Use only the Makita charger DC7021 to charge this
cleaner. Use of other type chargers may cause the
battery to burst, resulting in personal injury and damage.
Charge the cleaner when it is to be used for the first time
or it has been left uncharged for a long time. Connect
the charging plug to the charging connector, then plug in
the charger to the power receptacle. The light in front of
the cleaner switch will come on and charging will begin.
Charging takes approximately 3 - 5 hours. The light goes
out after the charging is complete. Refer to the
instruction manual for the charger for more details.
CAUTION:
Do not operate the cleaner during charging. It may
•
be damaged.
Always disconnect the charging plug from the
•
cleaner after charging.
When you charge a new cleaner or a cleaner
•
which has been left uncharged for a long time, it
may not accept a full charge. This is a normal
condition and does not indicate a problem. You can
recharge the cleaner fully after discharging it
completely a couple of times.
Maximum charging
•
depending on room temperature.
Switch action
Fig.3
CAUTION:
Always be sure that the dust bag or paper pack is
•
installed properly in the cleaner before use.
Improper installation may allow dust to enter the
motor, resulting in malfunction of the cleaner.
Always switch off the cleaner after each use to
•
prevent damage to the cleaner and to lengthen the
service life of the batteries.
This cleaner can be operated in "standard" and "strong"
suction. For standard suction, slide the switch forward to
the LOW position. For strong suction, slide the switch
further to the HIGH position.
To stop the cleaner, slide the switch back to the OFF
position.
ASSEMBLY
Dust disposal
CAUTION:
Empty the cleaner before it becomes too full, or the
•
suction force weakens.
time may be 9 hours
Be sure to empty out the dust inside the cleaner
•
itself. Failure to do so may cause the sponge filter
to be clogged or the motor to be damaged.
Never throw away the dust stopper because it
•
should be used whenever either the dust bag or
the dust pack is used.
Fig.4
Fig.5
Push the A part of the lever and grab it. Pull the lever in
the direction B to open the cover.
Fig.6
CAUTION:
Do not pull the lever in the direction C with
•
excessive force. Doing this may cause the lever to
be taken apart or damaged.
Fig.7
Pull out both the dust stopper and dust bag together at
the same time.
Fig.8
Fig.9
Remove the dust stopper and empty the cleaner.
Dust bag and paper pack
Install either dust bag or paper pack before using
cleaner.
Use the dust stopper when installing either dust bag or
paper pack.
Dust bag are usable many times repeatedly by cleaning
it out.
Paper pack is a throw-away type. Throw away the entire
paper pack without emptying when it has become full.
Installing dust bag
Fig.10
Use the dust stopper when installing dust bag. Be
careful not to take the upper side for the lower side by
mistake because they are different each other.
Fig.11
1. Insert the protrusion of the dust bag into the
groove in the dust stopper as shown in the figure.
Fig.12
2. There is no distinction between the upper and
lower sides of the dust bag. You may insert its
protrusion of any side into the lower groove of the
dust stopper.
Fig.13
3. Overlap the frame of dust stopper with that of the
dust bag.
Fig.14
4. Place the dust stopper and the dust bag together
into the cleaner cavity in the same direction of
arrow on the dust stopper. Insert them all the way
into the slots in the cleaner cavity.
7