Specifications - Makita LS1040 Instruction Manual

SPECIFICATIONS

Model ................................................................................................................................................... LS1040/LS1040S
Blade diameter..................................................................................................................................... 255 mm -260 mm
Hole diameter
For all countries other than European countries ............................................................................. 25.4 mm and 25 mm
For European countries ........................................................................................................................................ 30 mm
Max. Cutting capacities (H x W) with blade 260 mm in diameter
Bevel angle
0°
45° (left)
-1
No load speed (min ) ............................................................................................................................................. 4,600
Dimensions (L x W x H) .....................................................................................................530 mm x 476 mm x 532 mm
Net weight ............................................................................................................................................................... 11 kg
Safety class...............................................................................................................................................................
• Due to our continuing programme of research and development, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the tool. Be
sure that you understand their meaning before use.
...................Read instruction manual.
...................DOUBLE INSULATION
................Do not place hand or fingers close to
the blade.
................To avoid injury from flying debris,
keep holding the saw head down,
after making cuts, until the blade has
come to a complete stop.
................For your safety, remove chips, small
pieces, etc. from the table top before
operation.
............Always set SUB-FENCE to left posi-
tion when performing left bevel cuts.
Failure to do so may cause serious
injury to operator.
.....Turn clockwise the hex bolt to
remove.
2
0°
93 mm x 95 mm
69 mm x 135 mm
53 mm x 95 mm
35 mm x 135 mm
END217-2
Intended use
The tool is intended for accurate straight and miter cut-
ting in wood. With appropriate saw blades, aluminum
can also be sawed.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
Miter angle
45° (left and right)
93 mm x 67 mm
69 mm x 95 mm
49 mm x 67 mm
35 mm x 94 mm
..................Only for EU countries
Do not dispose of electric equipment
together with household waste mate-
rial!
In observance of European Directive
2002/96/EC on waste electric and
electronic equipment and its imple-
mentation in accordance with
national law, electric equipment that
have reached the end of their life
must be collected separately and
returned to an environmentally com-
patible recycling facility.
/II