Honeywell ADEMCO LYNXR-ISIA Installation And Setup Manual page 40

LYNXR-ISIA Installation and Setup Guide
✻ 81 Zone List Menu Mode
The following explains these prompts in detail. The left two columns identify the prompts and list the
available entries. The right-most column provides a further explanation of the entries.
Notes: (1) Entering a number other than one specified will give unpredictable results.
(2) Do not assign zones with zone types 20, 21 or 22 to a zone list.
(3) Zone List 2 should be used for Cross Zoning. When creating zone list 2 for cross zoning, include only 2 zones
assigned to zone types 3, 4, or 5. If interior zones (zone type 4) are cross zoned, then both zones in zone list 2 must
be interior zones. Do not cross zone more than 2 zones, or zone types that have delays (entry/exit zones, interior
w/delay), or 24-hour zones, as these choices may produce unpredictable operation and may not function as
intended. If cross zoning is used, zone list 2 should not be used for other purposes, such as triggering powerline
carrier devices. If field ✻39 has been set to "0" (no cross zoning), then Zone List 2 can be used for other purposes.
Zone list programming
0 = exit mode
8I
1 = enter mode
Zone list number
01-03 = zone list number to be programmed
A 0I
00 = exit Zone List mode
[✻] = continue
Zone entry to list
b
zz
01-41, 95, 96, 99 = zone numbers to add to zone
list
[✻] = accept zone number and enter the next zone
number
00 = accept zone number(s) and continue to next
prompt
Delete entire zone list?
0 = don't delete; continue to next prompt
C
1 = delete the current zone list
Delete zones from list?
d
1 = continue to delete zones prompt
0 = don't delete; continue to next zone list number
prompt (A....01)
[#] = return to zone list number prompt (A....01)
Delete zones
Enter each 2-digit zone number to be deleted from
E
the current zone list, followed by the [✻] key.
[✻] = delete zone and enter next zone to be
deleted
00 = delete zone and return to next zone list
number prompt (A....01) desired
Pressing 1 advances to the next prompt below.
Pressing 0 exits mode, upon which this prompt blinks, indicating the
mode is inactive.
Enter the Zone List Number 01, 02, or 03 to program (or 00 if no
zone lists are used).
Enter each zone number to add to the zone list by first entering the
zone number, then the [
system will announce the Voice Descriptor for the selected zone, if it
is programmed. After all desired zones are enrolled, enter "00" to
advance.
To delete the zone list, enter "1". All zones in the zone list will be
deleted automatically and programming will return to the ZONE
LIST NUMBER prompt.
To save the zone list or delete specific zones from the list, enter "0".
To save the entire zone list, enter "0" and programming will return
to the ZONE LIST NUMBER prompt.
To delete a zone or zones in a zone list enter "1".
When deleting a zone(s) from the zone list, if the selected zone has a
Voice Descriptor programmed, upon deletion it will be announced as
a confirmation that it has been deleted. After all zones to be deleted
are entered, enter "00" to return to the ZONE LIST NUMBER
prompt so that another list can be programmed, if desired.
- 40 -
✻ ✻ ✻
] key (for example, 01 02 03
✻
). The