Makita 6903VD Instruction Manual page 4

I .
SAVE THESE INSTRUCTIONS
-
This manual
Length of Cord (Feet)
AWG Size of Cord
contains important safety and operating instructions for battery charger.
2. Before using battery charger, read all instructions and cautionary markings
on (11 battery charger, (2) battery, and
(3)
product using battery.
3. CAUTION
-
To reduce risk of injury, charge only MAKITA Battery
7000,
9000
or
9100.
Other types of batteries may burst causing personal injury
and damage.
4.
Do not expose charger t o rain or snow.
5.
Use of an attachment not recommended or sold by the battery charger
manufacturer may result in a risk of fire, electric shock, or injury t o persons.
6. To reduce risk of damage t o electric plug and cord, pull by plug rather than
cord when disconnecting charger.
7.
Make sure cord is located so that it will not be stepped on, tripped over,
or otherwise subjected t o damage or stress.
8.
A n extension cord should not be used unless absolutely necessary. Use of
improper extension cord could result in a risk of fire and electric shock.
If
extension cord must be used, make sure:
a. That pins on plug of extension cord are
the
same number, size, and shape
b.
That extension cord is properly wired and in good electrical condition; and
c. That wire size is at least as large as the one specified in the table below.
TABLE 1
RECOMMENDED MINIMUM AWG SIZE
FOR
EXTENSION CORDS FOR BATTERY CHARGERS
as those of plug on charger;
25 50 100 150
18 18 18 16
4