How The Alarms Work; The Snooze Feature; Sleep Function - Horizon Fitness Trio Owner's Manual

How the Alarms Work

wake to tone – The alarm tone sounds at a low volume then gradually increases to full volume.
wake to Music – The radio station you selected is played at the volume level you selected with the Alarm Setup menu.
wake to Music and tone – First, the radio station is played. Then, after 5 minutes the alarm tone begins to sound.
To turn off the alarm press the
pOwer/vOluMe

The Snooze Feature

If you want to sleep a while longer after the alarm sounds you can use the
Snooze feature. Simply touch the metal rim around the front of the Trio. This
will delay the alarm for ten minutes. Each additional touch of the rim
increases the length of the Snooze alarm delay by 5 minutes. The maximum
delay is 60 minutes. The display initially shows the amount of "snooze time",
then reverts to normal time display. The highlight box of the alarm that is
"snoozing" flashes.
To the remaining snooze time, touch the metal trim ring. The display will show the amount of
snooze time remaining. Touching the metal trim ring again while the snooze time is displayed
increases the snooze time to the next higher step – 10 minutes, 15 minutes, 20 minutes, etc.
Each additional touch increases the snooze time by 5 minutes.
To cancel a "Snooze" time setting press the

Sleep Function

You can set the Trio to play any source for up to 90 minutes. After the specified time the Trio shuts off.
Use the control to select the source you want. Set the volume level where you want it.
1
MODe
Turn the control to highlight "Setup Options", then press the control. The "Setup Options" menu appears in the
2
MODe
display.
Turn the control to highlight "Sleep" then press the control. The highlight box around "Off" will flash.
3
MODe
Turn the or control clockwise to set the amount of time delay you want. You
4
MODe tune
can select from 5 to 90 minutes in 5 minute increments. Press the control.
The display example to the right shows the Sleep delay set for 20 minutes.
Turn the control to highlight "Exit" and press the control. Or wait a few seconds and
5
MODe
the display will "time out" automatically.
The display will go to its default mode – either source or time display, depending on what you
have chosen. The "S" Sleep icon will appear at the bottom center of the display.
This display example shows the "S" Sleep icon. The radio is tuned to 89.7, which is Preset 5. The
time is 10:40 PM and Alarm 2 is turned on.
Notes: To cancel the Sleep delay before it has finished press the
control.
control.
pOwer/vOluMe
pOwer/vOluMe
Touch Sensitive Rim
Touch Sensitive Rim
control to turn the Trio off.
E
N
G
L
I
S
H
11