Makita 9564PC Technical Information page 6

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -2. Spiral Bevel Gear 38 and Ball Bearing 6201DDW (Cont.)
ASSEMBLY
Do the reverse of the disassembling steps. Refer to Figs. 13 to 17(A).
Note: M4x16 Hex socket head bolts in Fig.13 are adhesive bolts. Apply ThreeBond 1321B/1342 or Loctite 242 to their
threaded portion before driving them.
[3] -3. Shaft Lock Mechanism
DISASSEMBLY
(1) Disassemble Gear housing complete from Motor housing. (Fig. 4)
(2) Remove Bearing box from Gear housing complete. (Fig. 13 or Fig. 13A)
(3) Disassemble the parts for Shaft lock mechanism as illustrated in Fig. 18 and 19.
Fig. 18
Pin cap
1R350
Applying 1R268 to Pin through the small hole on Pin cap,
strike 1R268 with Plastic hammer.
Now Pin comes out from Gear housing complete.
ASSEMBLY
(1) Be sure to use a new Pin cap for replacement and to remove all the plastic dust on Pin. (Fig. 20)
(2) Assemble the Parts for Shaft lock mechanism as illustrated in Fig. 21.
Fig. 20
Plastic dust
Pin
O ring 6
1R268
Pin
Fig. 21
Insert Pin through the hole
of Gear housing complete.
Fig. 19
Do not reuse Pin cap.
Removing Pin causes damages to the inside
surface of Pin cap.
Pin cap
Release 1R268 from Pin cap carefully so
that Pin cap is not slung by Compression
spring 8.
Assemble Pin cap by pressing it to Pin.
Pin
P 6 / 10
Pin cap
Compression spring 8
Pin cap
Compression spring 8
Do not forget to assemble
Compression spring 8.