Operation; Maintenance - Makita 6833 Instruction Manual

Number indicated on the plate
25/28
32
40
* 51
* 57
(Note) * for Model 6834 only
006404
Adjusting the driving depth
Fig.7
Depress the stopper base as far as it will go. While
keeping it in this position, turn the adjusting knob until
the bit tip projects approx. 5 mm from the stopper base.
Drive a trial screw. If the screw head projects above the
surface of the workpiece, turn the adjusting knob in the
"A" direction; if the screw head is counter-sunk, turn the
adjusting knob in the "B" direction.
Installing screw strip
Fig.8
Fig.9
Insert the screw strip through the screw guide. Then
insert it through the feeder box until the first screw
reaches the position next to the driving position.
Removing screw strip
Fig.10
Fig.11
To remove the screw strip, just pull it out in the direction
of the arrow. If you depress the reverse button, you can
pull out the screw strip in the reverse direction of the
arrow.
Extension handle (optional accessory)
Fig.12
Use of extension handle allows you to drive screws into
floors while standing.

OPERATION

Driving operation
Fig.13
Switch on the tool by pressing the switch trigger and at
the same time pushing the lock button. Hold the tool
squarely against the workpiece and apply forward
pressure to the tool. The screw will be automatically
carried to the driving position and driven into the
workpiece.
NOTE:
Do not fire the tool without screws. This will
•
damage the workpiece.
If the feeder box becomes sluggish in operation,
•
spray car wax (spray type wax) on its sliding
surfaces. Never lubricate it.
Screw length range
25 mm - 28 mm
28 mm - 35 mm
35 mm - 41 mm
41 mm - 51 mm
51 mm - 57 mm
Driving in corner
Fig.14
This tool can be used to drive at a position 15 mm away
from the wall as shown in the figure.
CAUTION:
Driving at a position closer than 15 mm to the wall
•
or driving with the stopper base in contact with the
wall may damage the screw heads and cause wear
on the bit. This may also lead to poor fastening of
screws and malfunction of the tool.

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Replacing carbon brushes
Fig.15
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
Fig.16
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Phillips bit
•
Drywall screw strips
•
Extension handle
•
Plastic carrying case
•
6
or attachments
Only use accessory or
are