Operation - Makita 9565PCV Instruction Manual

Then rotate the wheel guard around 180 degrees
counterclockwise. Be sure to tighten the screw securely.
To remove wheel
procedure in reverse.
For tool with clamp lever type wheel guard
Fig.6
Fig.7
Pull the lever in the direction of the arrow after
loosening the screw. Mount the wheel guard with the
protrusion on the wheel guard band aligned with the
notch on the bearing box. Then rotate the wheel guard
around 180°. Fasten it with the screw after pulling lever
in the direction of the arrow for the working purpose.
The setting angle of the wheel guard can be adjusted
with the lever.
To remove wheel
procedure in reverse.
Installing or removing depressed center
grinding wheel/Multi-disc (accessory)
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
onto the spindle.
Fig.8
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise. To remove the wheel,
follow the installation procedure in reverse.
Fig.9
Installing or removing abrasive disc
(optional accessory)
Fig.10
NOTE:
Use sander accessories specified in this manual.
•
These must be purchased separately.
Mount the rubber pad onto the spindle. Fit the disc on
the rubber pad and screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
To remove the disc, follow the installation procedure in
reverse.

OPERATION

WARNING:
It should never be necessary to force the tool. The
•
weight of the tool applies adequate pressure.
Forcing and excessive pressure could cause
dangerous wheel breakage.
ALWAYS replace wheel if tool is dropped while
•
grinding.
NEVER bang or hit grinding disc or wheel onto
•
work.
guard, follow the
guard, follow the
Avoid
•
especially when working corners, sharp edges etc.
installation This can cause loss of control and kickback.
NEVER use tool with wood cutting blades and
•
other sawblades. Such blades when used on a
grinder frequently kick and cause loss of control
leading to personal injury.
CAUTION:
After operation, always switch off the tool and wait
•
until the wheel has come to a complete stop
before putting the tool down.
Grinding and sanding operation
Fig.11
ALWAYS hold the tool firmly with one hand on housing
and the other on the side handle. Turn the tool on and
installation
then apply the wheel or disc to the workpiece.
In general, keep the edge of the wheel or disc at an
angle of about 15 degrees to the workpiece surface.
During the break-in period with a new wheel, do not
work the grinder in the B direction or it will cut into the
workpiece. Once the edge of the wheel has been
rounded off by use, the wheel may be worked in both A
and B direction.
Operation with wire cup brush / wire bevel
brush (optional accessory)
Fig.12
CAUTION:
Check operation of brush by running tool with no
•
load, insuring that no one is in front of or in line
with brush.
Do not use brush that is damaged, or which is out
•
of balance. Use of damaged brush could increase
potential for injury from contact with broken brush
wires.
Unplug tool and place it upside down allowing easy
access to spindle. Remove any accessories on spindle.
Thread wire cup brush / wire bevel brush onto spindle
and tighten with supplied wrench. When using brush,
avoid applying too much pressure which causes over
bending of wires, leading to premature breakage.
8
bouncing and snagging the wheel,